Tomahawk Drift
Tear Drop Shaped Tomahawk Drift
The drift is approx. 11" long and tear drop shaped to form the hole needed to handle hand made hammers, tomahawks etc. The tool measures 1/2 x 3/4 at the small end and tapers up to 7/8 x 1 1/4 at the large end. The process used buy most smiths is to drill a series of small holes as close together in the center of the workpiece to be drifted. Once the holes are drilled heat the item and use a cold chisel or similar tool to split the piece. Once split, heat the piece again and drive the drift through the hole. Tap the sides of the workpiece while continuing to drive the drift into the workpiece until the drift hole gets to the desired measurement. The process of heating may be needed several times to get the desired shape. The tool is made of tough 60/45 ductile iron. These castings have been produced for many years and have proven to be very reliable and useful. Casting weighs approx.4 lbs. Made in the USA!
Tear Drop Shaped Tomahawk Drift
The drift is approx. 11" long and tear drop shaped to form the hole needed to handle hand made hammers, tomahawks etc. The tool measures 1/2 x 3/4 at the small end and tapers up to 7/8 x 1 1/4 at the large end. The process used buy most smiths is to drill a series of small holes as close together in the center of the workpiece to be drifted. Once the holes are drilled heat the item and use a cold chisel or similar tool to split the piece. Once split, heat the piece again and drive the drift through the hole. Tap the sides of the workpiece while continuing to drive the drift into the workpiece until the drift hole gets to the desired measurement. The process of heating may be needed several times to get the desired shape. The tool is made of tough 60/45 ductile iron. These castings have been produced for many years and have proven to be very reliable and useful. Casting weighs approx.4 lbs. Made in the USA!
